Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Meter, Warning Lamp & Indicator :: Type B / Dtc/circuit Diagnosis / B2267-29 Engine Speed

Nissan Sentra B18 (2020-2025) Service Manual: B2267-29 Engine Speed

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detected condition
B2267-29	TACHO METER (Tacho meter)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	Engine speed signal
		Threshold	ECM continuously transmits abnormal engine speed signals
		Diagnosis delay time	2 seconds or more

POSSIBLE CAUSE

Crankshaft position sensor (POS)

FAIL-SAFE

Reset to zero of the tachometer by suspending communication.

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “METER/M&A”.
Is DTC B2267-29 detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM SELF DIAGNOSTIC RESULT OF ECM
1. CONSULT
  
  Select “Self Diagnostic Result” mode of “ENGINE”.
Is DTC detected?
YES >>
Perform diagnosis procedure on the detected DTC. Refer to DTC Index.
NO >>
Inspection End.

 B2231-16 Battery Voltage

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detected condition B2231-16 Battery voltage (Battery voltage) Di...

 U1321-55 Configuration Unfinished

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1321–55 Config unfinished (Configuration ...

Other materials:

Heated Steering Wheel System
Component Function Check Component Function Check CHECK HEATED STEERING WHEEL SYSTEM Check operate heated steering wheel system. Refer to System Description. Is the inspection result normal? YES >> I ...

Brake Lines and Cables
Inspection Inspection BRAKE LINE Check brake line (tubes and hoses) for cracks, deterioration or other damage. Replace any damaged parts. Check for brake fluid leaks by fully depressing brake pedal while engine is running. CAUTION: ...

Stop Lamp Switch
Component Inspection Component Inspection CHECK STOP LAMP SWITCH 1 Ignition switch OFF. Disconnect stop lamp switch connector. Check continuity betwe ...