Nissan Sentra B18 (2020-2025) Service Manual: Dtc Confirmation Procedure
-
PERFORM DTC CONFIRMATION
-
CONSULT-
Ignition switch ON.
CAUTION:
Never start the engine.
-
Check the tire pressure for all wheels and adjust to the specified value. Refer to Tire Air Pressure.
-
Select “Self Diagnostic Result” mode of “BCM(AIR PRESSURE MONITOR)”.
-
Drive the Nissan Sentra vehicle at 25 MPH (40 km/h) or more reaches 10 minuets in total.
-
Is DTC “C1713-7B" detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
-
Dtc Description
DTC Description
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional information.
...
Dtc Diagnosis Procedure
DTC Diagnosis
Procedure
Note:
The Signal Tech II Tool [– (NI-50190)] can be used
to perform the following functions: Refer to the Signal Tech II User
Guide for additional informatio ...
Other materials:
Seat Belt, Buckles, Retractors, Anchors and Adjusters
Inspection
Inspection
CAUTION:
After any collision, inspect all seat belt
assemblies, including retractors and other attached hardware (i.e.
anchor bolt, guide rail set). NISSAN recommends to replace all seat
belt assemblies in use during a c ...
Air cleaner
The viscous paper-type air cleaner filter element used in the Nissan Sentra is
designed for single use only and must not be cleaned or reused. The filter should
be replaced according to the maintenance intervals listed in the "Maintenance and
schedules" section of this manual to ...
B24a4-15 Intake Sensor
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
...
