Nissan Sentra Service Manual: Dtc/circuit diagnosis
- Power supply routing circuit
- Ground
- Electrical units location
- Harness connector
- Standardized relay
- Fuse block - junction box (J/B)
- Fuse, fusible link and relay box
- Ipdm e/r (intelligent power distribution module engine room)
Inspection and adjustment
Additional service when removing battery negative
terminal
Additional service when removing battery negative
terminal : special repair requirement
Required procedure after battery disconnection
...
Power supply routing circuit
Wiring Diagram — Battery Power Supply —
Wiring Diagram — Accessory Power Supply —
Wiring Diagram — Ignition Power Supp ...
Other materials:
Hvac branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the a/c auto amp. For damage, bend
and loose connection (unit
side and connector side).
Is the inspection result normal? ...
Output speed sensor
Exploded View
Transaxle assembly
Output speed sensor
O-ring
: Vehicle front
: Always replace after every
disassembly.
: NВ·m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-3
Removal and Installation
REMOVAL
Disconnect the output speed sensor harness connector.
Remove ...
Removal and installation
SIDE OIL SEAL
Removal and Installation
REMOVAL
Remove front drive shafts. Refer to FAX-18, "6M/T : Removal and
Installation (LH)".
Remove differential side oil seals (1) from clutch housing and
transaxle case using a suitable tool.
CAUTION:
Do not damage transaxle case an ...
