Description
The daytime light system is inoperative even though the combination switch (lighting and turn signal switch) and parking brake switch are in the normal setting, also whenever engine is operating.
Diagnosis procedure
1.Check daytime light operation
Is the inspection results normal? Yes >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).
No >> go to 2.
2.Check daytime light relay fuse

Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 3.
3.Check daytime light bulbs
Check the daytime light bulbs are not open.
Is the inspection result normal? Yes >> go to 4.
No >> replace the bulbs.
4.Perform daytime light circuit inspection
Check the daytime light circuit. Refer to exl-92, "diagnosis procedure".
Is the inspection results normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).
No >> repair or replace the malfunctioning part.
Both side headlamps do not switch
to high beam
Both side headlamps (lo) are not
turned onThree-point type seat belt with retractor
WARNING
Every person who drives or rides in this
vehicle should use a seat belt at all
times.
Do not ride in a moving vehicle when
the seatback is reclined. This can be
dangerous. The shoulder belt will not
be against your body. In an accident,
you could be thr ...
Horn
To sound the horn, push near the horn icon on the
steering wheel.
WARNINGDo not disassemble the horn. Doing so
could affect proper operation of the
supplemental front air bag system. Tampering
with the supplemental front air bag
system may result in serious personal
injury. ...
U1117 Lost communication (ABS)
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
[Trouble diagnosis content]
DTC detection condition
Possible causes
U1117
LOST COMM (ABS)
[Lost Communication With
ABS]
When the ignition switch is ON, TCM is unable
to receive the CAN communications ...