Nissan Sentra Service Manual: Parking, license plate and tail lamps are not turned on
Description
The parking, license plate and tail lamps do not turn on in with any lighting switch setting.
Diagnosis procedure
1.Combination switch (lighting and turn signal switch) inspection
Check the combination switch (lighting and turn signal switch). Refer to BCS-72, "Symptom Table" (with Intelligent Key system) or BCS-125, "Symptom Table" (without Intelligent Key system).
Is the inspection results normal? YES >> GO TO 2
NO >> Repair or replace the malfunctioning part.
2.Check tail lamp relay request signal input
Consult data monitor
- Select TAIL & CLR REQ of IPDM E/R DATA MONITOR item.
- While operating the lighting switch, check the monitor status.
Is the inspection results normal? YES >> GO TO 3
No >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).
3.Park lamp circuit inspection
Check the parking lamp circuit. Refer to exl-96, "diagnosis procedure".
Is the inspection results normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).
No >> repair or replace the malfunctioning part.
Both side headlamps (lo) are not
turned on
Description
The headlamps (both sides) do not turn on in any lighting switch setting.
Diagnosis Procedure
1.Check combination switch (lighting and turn signal switch)
Check the combination switc ...
Both side front fog lamps are not
turned on
Description
The front fog lamps do not turn on in any setting.
Diagnosis procedure
1.Combination switch (lighting and turn signal switch) inspection
Check the combination switch (lighting and turn ...
Other materials:
U1000 CAN Comm circuit
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
U1000
CAN COMM CIRCUIT
When CAN communication signal is not continuously
received for 2 seconds or more
CAN communication system malfunction
Diagnosis Procedure
...
Eps warning lamp does not turn on
Description
EPS warning lamp does not turn ON when turning ignition switch
ON from OFF. (Check the illumination of the
EPS warning lamp.)
Diagnosis Procedure
1.CHECK EPS WARNING LAMP
Perform the trouble diagnosis of EPS warning lamp. Refer to
STC-31, "Diagnosis Procedure".
Is ...
Steering angle sensor
Exploded View
Steering angle sensor
Screw
Front
Removal and Installation
REMOVAL
Remove spiral cable assembly. Refer to SR-16, "Removal and
Installation".
Remove the two screws and the steering angle sensor from
spiral cable.
INSTALLATION
Ins ...
