Nissan Sentra Service Manual: Both side front fog lamps are not turned on
Description
The front fog lamps do not turn on in any setting.
Diagnosis procedure
1.Combination switch (lighting and turn signal switch) inspection
Check the combination switch (lighting and turn signal switch). Refer to bcs-72, "symptom table" (with intelligent key system) or bcs-125, "symptom table" (without intelligent key system).
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace the malfunctioning part.
2.Check front fog lamp request signal input
Consult data monitor
- Select FR FOG REQ of IPDM E/R DATA MONITOR item.
- While operating the front fog lamp switch, check the monitor status.
Is the inspection result normal? Yes >> go to 3.
No >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).
3.Front fog lamp circuit inspection
Check the front fog lamp circuit. Refer to EXL-94, "Diagnosis Procedure".
Is the inspection result normal? YES >> Replace IPDM E/R. Refer to PCS-30, "Removal and Installation" (with Intelligent Key system) or PCS-58, "Removal and Installation" (without Intelligent Key system).
NO >> Repair or replace the malfunctioning part.
Parking, license plate and tail
lamps are not turned on
Description
The parking, license plate and tail lamps do not turn on in with any lighting
switch setting.
Diagnosis procedure
1.Combination switch (lighting and turn signal switch) inspection
Ch ...
Other materials:
Removal and installation
EXHAUST SYSTEM
Exploded View
Sub muffler
Spring
Mounting rubber
Seal bearing
Catalyst shroud (upper)
Seal bearing
Exhaust front tube
Spring
Catalyst shroud (lower)
Clamp
Heated oxygen sensor 2
Ring gasket
Mounting rubber
Main muffler
Exhaust finisher (if equipped ...
Consult function
FUNCTION
Diagnostic test mode
Function
Self Diagnostic Results
Self-diagnostic results such as 1st trip DTC, DTCs and 1st trip
freeze frame data or freeze frame data
can be read and erased quickly.*
Data Monitor
Input/Output data in the ECM can be read.
...
Precautions for Suspension
When installing rubber bushings, the final tightening must be carried
out under unladen conditions with tires
on ground. Spilled oil might shorten the life of rubber bushings. Be sure to
wipe off any spilled oil.
Unladen conditions mean that fuel, engine coolant and lubricant are
...
