Nissan Sentra Service Manual: Both side headlamps (lo) are not turned on
Description
The headlamps (both sides) do not turn on in any lighting switch setting.
Diagnosis Procedure
1.Check combination switch (lighting and turn signal switch)
Check the combination switch (lighting and turn signal switch). Refer to BCS-72, "Symptom Table" (with Intelligent Key system) or BCS-125, "Symptom Table" (without Intelligent Key system).
Is the inspection result normal? YES >> GO TO 2
No >> repair or replace the malfunctioning part
2.Check headlamp (lo) request signal input
Consult data monitor
- Select hl lo req of ipdm e/r data monitor item.
- While operating the lighting switch, check the monitor status.
Is the inspection result normal? Yes >> go to 3
No >> replace bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs- 126, "removal and installation" (without intelligent key system).
3.Headlamp (lo) circuit inspection
Check the headlamp (lo) circuit. Refer to exl-90, "diagnosis procedure".
Is the inspection result normal? Yes >> replace ipdm e/r. Refer to pcs-30, "removal and installation" (with intelligent key system) or pcs-58, "removal and installation" (without intelligent key system).
No >> repair or replace the malfunctioning part.
Daytime light system inoperative
Description
The daytime light system is inoperative even though the combination switch
(lighting and turn signal switch)
and parking brake switch are in the normal setting, also whenever engine is ...
Parking, license plate and tail
lamps are not turned on
Description
The parking, license plate and tail lamps do not turn on in with any lighting
switch setting.
Diagnosis procedure
1.Combination switch (lighting and turn signal switch) inspection
Ch ...
Other materials:
Service data and specifications (SDS)
General Specifications
Clutch Pedal
Clutch Disc
Clutch Cover
...
P0846 Transmission fluid pressure SEN/SW B
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0846
TRANSMISSION FLUID
PRESSURE SEN/SW B
(Transmission Fluid Pressure
Sensor/Switch B Circuit
Range/Performance)
The detection ...
Moonroof switch
Description
Transmits switch operation signal to moonroof motor assembly.
Diagnosis Procedure
Regarding Wiring Diagram information, refer to RF-13, "Wiring Diagram".
1.Check moonroof switch input signal
Turn ignition switch on.
Check voltage between moonroof motor assembly harne ...
