Nissan Sentra B18 (2020-2025) Service Manual: Consult Data Link Connector (dlc) Circuit

Nissan Sentra B18 (2020-2025) Service Manual / General Information / General Information :: Basic Inspection / Consult Checking System / Consult Data Link Connector (dlc) Circuit

CONSULT Data Link Connector (DLC) Circuit

INSPECTION PROCEDURE

If the CONSULT cannot diagnose the system properly, check the following items.

Symptom	Check item
CONSULT cannot access any system.	CONSULT DLC power supply circuit (Terminal 8 and 16) and ground circuit (Terminal 4 and 5)
CONSULT cannot access individual system. (Other systems can be accessed.)	Power supply and ground circuit for the control unit of the system (For detailed circuit, refer to wiring diagram for each system.) Open or short circuit between the system and CONSULT DLC (For detailed circuit, refer to wiring diagram for each system.) Open or short circuit CAN communication line. Refer to Trouble Diagnosis Flow Chart.

Note:

The DDL2 circuits and CAN communication lines from DLC pins 6, 7 and 14 may be connected to more than one system. A short in a DDL circuit or CAN lines connected to a control unit in one system may affect CONSULT access to other systems.

For a complete DDL circuit layout, refer to:

Wiring Diagram

For a complete CAN line layout, refer to:

Wiring Diagram

Function and System Application

Function and System Application FUNCTION Mode Function A ...

Additional Service When Removing Battery Negative Terminal

...

Other materials:

Unexpected pedal reaction
Diagnosis Procedure 1.CHECK BRAKE PEDAL STROKE Check brake pedal stroke. Refer to BR-15, "Adjustment". Is the stroke too big? YES >> Bleed air from brake line and hose. Refer to BR-17, "Bleeding Brake System". Check brake pedal, brake booster, and maste ...

Moonroof
Power moonroof The power moonroof on the Nissan Sentra operates only when the ignition switch is placed in the ON position, providing controlled and safe operation while driving. In addition, the power moonroof remains operational for a short period even after the ignition switch is moved ...

Additional service when replacing ecm
Description When replacing ECM, the following procedure must be performed. (For details, refer to EC-135, "Work Procedure".) PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sure to follow the procedure to perform t ...