Nissan Sentra B18 (2020-2025) Service Manual: Confirmation Procedure

Nissan Sentra B18 (2020-2025) Service Manual / Steering / Steering Control System :: Dtc/circuit Diagnosis / C1623-87 Ecm System / Confirmation Procedure

Confirmation Procedure

PRECONDITIONING
1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
DTC REPRODUCTION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1623-87” detected?
YES >>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Description

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis cont ...

Dtc Diagnosis Procedure

DTC Diagnosis Procedure PERFORM SELF DIAGNOSTIC RESULT CONSULT Ignition switch ON. ...

Other materials:

Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The supplemental restraint system such as вЂњair bagвЂќ and вЂњseat belt pre-tensionerвЂќ, used along with a front seat belt, helps to reduce the risk or severity of inju ...

Special Service Tool
Special Service Tool Tool number (TechMate No.) Tool name Description 165-GR8-1200KIT (—) Midtroni ...

Air Bleeding
Air Bleeding CAUTION: When air bleeding the clutch, be careful not to let the fluid level fall below the MIN line on the reservoir tank. Do not spill clutch fluid onto painted surfaces. If fluid spills, wipe up immediately ...