CAUTION:
When air bleeding the clutch, be careful not to let the fluid level fall below the MIN line on the reservoir tank.
Do not spill clutch fluid onto painted surfaces. If fluid spills, wipe up immediately and wash the affected area with water.
Fill reservoir tank with new clutch fluid.
CAUTION:
Do not reuse drained clutch fluid.
Connect a
transparent vinyl hose to air bleeder of bleeding connector
(1). 
Depress and release the clutch pedal slowly and fully 15 times at an interval of 2 to 3 seconds and release the clutch pedal.
Press the
lock pin (1) into the bleeding connector (2), and maintain the
position.
Slide
bleeding connector (1) in the direction of the arrow (
) as shown and
immediately depress the clutch
pedal and hold it, to bleed the air from the system.
|
(2) |
: Clutch housing |
|
Dimension (A) |
: 10 mm (0.39 in) |
CAUTION:
Clutch tube is under hydraulic pressure; do not allow the clutch tube to disconnect from the clutch housing.
Return clutch tube and lock pin in their original positions.
Release clutch pedal and wait for 5 seconds.
Repeat steps 3 to 7 until no bubbles are observed in the clutch fluid.
Check that the fluid level in the reservoir tank is within the specified range after air bleeding. Refer to Inspection.
RefillingComponent parts
Engine control system
ENGINE CONTROL SYSTEM :Component Parts Location
Engine room compartment
No.
Component
Function
1
IPDM E/R
IPDM E/R control the internal relays and the actuators.
When CAN communication with ECM is impossible, IPDM
E/R performs fail-sa ...
DTC/Circuit diagnosis
POSITION SWITCH
BACK-UP LAMP SWITCH
BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH
Disconnect position switch harness connector. Refer to TM-21, "Removal
and Installation".
Check continuity between position switch terminals.
Is the inspection ...
Trip Reset Switch
Exploded View
Exploded View
1.
Trunk lid opener switch
2.
ECO mode switch
3.
...