Nissan Sentra Service Manual: DTC/Circuit diagnosis
POSITION SWITCH
BACK-UP LAMP SWITCH
BACK-UP LAMP SWITCH : Component Inspection
1.CHECK BACK-UP LAMP SWITCH
- Disconnect position switch harness connector. Refer to TM-21, "Removal and Installation".
- Check continuity between position switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-21, "Removal and Installation".
PARK/NEUTRAL POSITION (PNP) SWITCH
Park/neutral position (PNP) Switch :Component Inspection
1.CHECK PARK/NEUTRAL POSITION (PNP) SWITCH
- Disconnect position switch harness connector. Refer to TM-21, "Removal and Installation".
- Check continuity between position switch terminals.
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace position switch. Refer to TM-21, "Removal and Installation".
System description
COMPONENT PARTS
Component Parts Location
Transaxle assembly
STRUCTURE AND OPERATION
Sectional View
3rd input gear
3rd-4th synchronizer hub assembly
4th input gear
5th ...
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. The numbers indicate
the order of the inspection. If necessary ...
Other materials:
Battery
How to handle battery
CAUTION:
If it becomes necessary to start the engine with a booster battery
and jumper cables, use a 12-volt
booster battery.
After connecting battery cables, ensure that they are tightly
clamped to battery terminals for good
contact.
Never add distilled wat ...
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
The supplemental restraint system such as “air bag” and “seat belt pre-tensioner”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system ...
Radio
With the ignition placed in the ACC or ON position,
press the PWR (power)/VOL (volume) knob
to turn the radio on. If you listen to the radio with
the engine not running, the ignition should be
placed in the ACC position.
Radio reception is affected by station signal
strength, distance from r ...
