PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
Select "Self Diagnostic Result" mode of “ENGINE”.
Is any DTC detected?
YES >>Check the DTC. Refer to DTC Index.
NO >>GO TO 2.
CHECK CONNECTOR AND TERMINAL
Ignition switch OFF.
Disconnect ECM harness connector.
Disconnect EPS control unit harness connector.
Check the connector for disconnection or looseness.
Check the pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES >>GO TO 3.
NO >>Repair or replace harness, connector, or terminal, securely lock the connector.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Connect ECM harness connector.
Connect EPS control unit harness connector.
Ignition switch ON.
Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
Ignition switch OFF and wait for at least 10 seconds.
Ignition switch ON.
Select "Self Diagnostic Result" mode of “EPS/DAST 3”.
Is DTC “C1623-87” detected?
YES >>EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.
NO >>Inspection End.
Confirmation ProcedureInspection
Inspection
COMPONENT PART
Check that the mounting conditions (looseness,
backlash) of each component and component conditions (wear, damage)
are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED
TYPE)
Check the following items, and replace the part
if necessary.
Move the
...
System description
Component parts
Component parts location
Front tweeter LH
GPS antenna
Steering switches
AV control unit
Front tweeter RH
Microphone
Front door speaker LH
Front door speaker RH
Rear door speaker LH
Rear door speaker RH
Rear woofer RH
Rear woofer LH
Antenna amp
Satel ...
Dtc Diagnosis Procedure
DTC Diagnosis
Procedure
CHECK FUSE
Ignition switch OFF.
Check that the following fuse is not blown (open):
...