Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual: C1624-00 Signal Connector

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

C1624-00

Signal connector

(Signal connector)

Diagnosis condition

When engine running.

Signal (terminal)

-

Threshold

When the malfunction is detected in EPS control unit signal connector.

Diagnosis delay time

2 seconds or more

POSSIBLE CAUSE

  • Harness or connector

  • EPS control unit

FAIL-SAFE

Slowly reducing assistance

Confirmation Procedure

Confirmation Procedure

  1. PRECONDITIONING

    1. If “Confirmation Procedure” has been previously conducted, always place the ignition switch OFF and wait at least 10 seconds before conducting the next test.

    >>

    GO TO 2.

  2. DTC REPRODUCTION PROCEDURE

    1. CONSULT

      1. Ignition switch ON.

      2. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.

    Is DTC “C1624-00” detected?

    YES >>

    Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.

    NO >>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO >>

    Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. CHECK TERMINALS AND HARNESS CONNECTORS

    1. Check EPS control unit pin terminals for damage or loose connection with harness connector.

    Is the inspection result normal?

    YES >>

    GO TO 2.

    NO >>

    Repair or replace error-detected parts.

  2. PERFORM SELF DIAGNOSTIC RESULT

    1. CONSULT

      1. Ignition switch ON.

      2. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".

      3. Ignition switch OFF, and then wait 10 seconds and more.

      4. Start the engine.

        CAUTION:

        Never drive the Nissan Sentra vehicle.

      5. Select "Self Diagnostic Result" mode of “EPS/DAST 3”.

    Is DTC “C1624-00” detected?

    YES >>

    EPS control unit is malfunctioning. Replace steering gear assembly. Refer to Removal and Installation.

    NO >>

    Inspection End.

    C1623-87 Ecm System
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1623-87 ECM system (Engine control module s...
    C1629-87 Ipdm E/r System
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C1629-87 IPDM E/R system (Intelligent power ...

    Other materials:

    Power Supply and Ground Circuit
    Diagnosis Procedure Diagnosis Procedure CHECK FUSE Check that the following fuses are not blown: ...

    Abs Warning Lamp
    Component Function Check Component Function Check CHECK ABS WARNING LAMP FUNCTION Check that ABS warning lamp in combination meter turns ON for 1 second after ignition switch is placed ON. CAUTION: Never start th ...

    Traffic Sign Recognition (TSR)
    The Traffic Sign Recognition (TSR) system in the Nissan Sentra provides the driver with information about the most recently detected speed limit and certain traffic signs. The system captures road sign data using the multi-sensing front camera unit (A), which is mounted on the windshield i ...