Nissan Sentra B18 (2020-2025) Service Manual / Electrical & Power Control / Charging System :: Removal and Installation. Generator

Nissan Sentra B18 (2020-2025) Service Manual: Charging System :: Removal and Installation. Generator

Generator. Exploded View

Exploded View

1.	Generator	A.	Refer to Removal and Installation.	B.	"B" terminal harness
C.	Harness connector		Front

Removal and Installation

REMOVAL

Disconnect the battery negative terminal. Refer to Battery Disconnect.

Remove intake manifold. Refer to Removal and Installation.

Partially remove front fender protector (RH). Refer to Exploded View — Front Fender Protector.

Remove drive belt. Refer to Removal and Installation.

Disconnect harness connector from generator.

Remove “B" terminal nut and harness.

Remove generator bolts and generator from Nissan Sentra vehicle.

INSTALLATION

Install generator using the following procedure: Temporarily tighten bolts in the reverse sequence shown. Torque bolts to specification in the sequence shown.

Bolts

:25.0 N·m (2.6 kg-m, 18 ft-lb)

Installation of remaining components is in the reverse order of removal.

CAUTION:

Tighten "B" terminal nut carefully and to specification. Refer to Exploded View.

Inspection

Perform the following:

Make sure that generator pulley does not rattle.

Make sure that generator pulley nut is tight. Note:

Replace generator as an assembly if necessary.

 Charging System. Symptom Diagnosis. Charging System. Symptom Table

Charging System. Symptom Table Symptom Table Symptom Table Symptom Reference Battery discharged Refer to Work Flow (With 165-DSS-5000P) or Work Flow (Without 165-DSS-5000P). The...

 Charging System. Service Data and Specifications (sds). Service Data and Specifications (sds). Generator

Service Data and Specifications (sds). Generator Generator Generator Type MR20DD F000BL079B SEG AUTOMOTIVE Nominal rating [V - A] 14V-120A Ground polarity Negative Minimum revol...

Other materials:

U2152-87 Can Comm Err (adas Control Unit)
Dtc Description DTC Description DESCRIPTION CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Sentra vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan ...

Roof. Ecu Diagnosis Information. Moonroof Motor Assembly. Reference Value
Moonroof Motor Assembly. Reference Value Reference Value Reference Value TERMINAL LAYOUT PHYSICAL VALUES Terminal No. (Wire color) Description ...

Before Replacing ECM
SAVE ECM DATA With CONSULT Turn ignition switch OFF. Reconnect all harness connectors disconnected. Turn ignition switch ON. Select “SAVING DATA FOR REPLC ...