Diagnosis Procedure
Both side headlamps (HI) are not turned ON when setting to the lighting switch HI or PASS.
COMBINATION SWITCH INSPECTION
Check combination switch. Refer to Symptom Table.
Is the inspection result normal?
YES >>GO TO 2.
NO >>Repair or replace the malfunctioning part.
CHECK HIGH BEAM REQUEST SIGNAL
CONSULT
Select “HIGH BEAM REQ” and “PASSING REQ” in “Data Monitor” mode of “IPDM E/R”.
With operating the lighting switch, check the monitor status.
|
Monitor item |
Condition |
Monitor status |
|
|---|---|---|---|
|
HIGH BEAM REQ |
Lighting switch (2ND) |
HI |
On |
|
LO |
Off |
||
|
PASSING REQ |
Lighting switch |
PASS |
On |
|
OFF |
Off |
||
Is the inspection result normal?
YES >>Replace IPDM E/R. Refer to Removal and Installation.
NO >>Replace BCM. Refer to Removal and Installation.
Exterior Lighting System SymptomsEvap canister
Exploded View
EVAP canister bracket
EVAP canister filter drain hose
EVAP canister filter
EVAP canister protector
EVAP hose
EVAP canister vent control valve
O-ring
EVAP canister
O-ring
EVAP canister control pressure sensor
Clip
Nut
Removal and Installation
EVAP ...
Door outside molding
Exploded view
Front door assembly
Grommet
Front door outside molding
Rear door outside molding
Rear door assembly
Door glass
Clip
Front door outside molding
FRONT DOOR OUTSIDE MOLDING : Removal and Installation
REMOVAL
Remove front door mirror. Refer to MIR-18, &quo ...
Compressor
Exploded view
With air conditioning
Compressor
Front
Without air conditioning
A/c idler pulley
A/c idler pulley bracket
Compressor
Compressor : removal and installation
REMOVAL
Discharge the refrigerant. Refer to ha-23, "recycle refrigerant".
Remove the fr ...