Nissan Sentra manuals

Nissan Sentra B18 (2020-2025) Service Manual: Board-On Lift

Board-on Lift

CAUTION:

Make sure vehicle is empty when lifting.

  • The board-on lift attachment (A) set at front end of Nissan Sentra vehicle should be set on the front of the sill under the front door opening.

  • Position attachments at front and rear ends of board-on lift.

: Nissan Sentra Vehicle front

Garage Jack and Safety Stand and 2-Pole Lift
Garage Jack and Safety Stand and 2-Pole Lift Warning: Park the vehicle on a level surface when using the jack. Make sure to avoid damaging pipes, tubes, etc. und ...

Tow Truck Towing
...

Other materials:

C1142 Press sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1142 PRESS SEN CIRCUIT When a malfunction is detected in master cylinder pressure sensor. Stop lamp switch system ABS actuator and electric unit (co ...

Illumination control switch
Removal and installation Removal Remove instrument finisher d. Refer to ip-14, "exploded view". Remove the illumination control switch (1) from the switch carrier (2) using suitable tool (a). : Pawl Installation Installation is in the reverse order of removal. ...

Around View Monitor Control Unit
Values on the Diagnosis Tool Values on the Diagnosis Tool Note: The following table includes information (items) inapplicable to this Nissan Sentra vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items. ...

В© 2014-2026 Copyright www.nisentra.com