Nissan Sentra B18 (2020-2025) Service Manual: Lifting Point
Special Service Tool
Special Service Tool
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
|
Tool number (Kent-Moore No.) Tool name |
Description |
|---|---|
|
LM4086-0200 ( - ) Board on attachment |
![]() |
|
LM4519-0000 ( - ) Safety stand attachment |
![]() |
CAUTION:
-
Every time the Nissan Sentra vehicle is lifted up, maintain the complete vehicle curb condition.
-
Since the vehicle's center of gravity changes when removing main parts on the front side (engine, transmission, suspension etc.), support a jack up point on the rear side garage jack with a transmission jack or equivalent.
-
Since the Nissan Sentra vehicle's center of gravity changes when removing main parts on the rear side (rear axle, suspension, etc.), support a jack up point on the front side garage jack with a transmission jack or equivalent.
-
Be careful not to smash or do anything that would affect piping parts.
Garage Jack and Safety Stand and 2-Pole Lift
Garage Jack and Safety Stand and 2-Pole Lift
Warning:
-
Park the vehicle on a level surface when using the jack. Make sure to avoid damaging pipes, tubes, etc. under the Nissan Sentra vehicle.
-
Never get under the vehicle while it is supported only by the jack. Always use safety stands when you have to get under the Nissan Sentra vehicle.
-
Place wheel chocks at both front and back of the wheels on the ground.
-
Lift at reinforced area of front suspension member where lower control arm attaches, staying in center line of wheels.
-
When lifting the Nissan Sentra vehicle, open the lift arms as wide as possible and ensure that the front and rear of the vehicle are well balanced.
-
When setting the lift arm, do not allow the arm to contact the brake tubes, brake cable, fuel lines and sill spoiler.
|
1. |
Safety stand point and lift up point (front) |
2. |
Safety stand point and lift up point (rear) |
Board-On Lift
Board-on Lift
CAUTION:
Make sure vehicle is empty when lifting.
-
The board-on lift attachment (A) set at front end of Nissan Sentra vehicle should be set on the front of the sill under the front door opening.
-
Position attachments at front and rear ends of board-on lift.
|
|
: Nissan Sentra Vehicle front |
Other materials:
Door Lock Function
System Diagram
System Diagram
System Description
System Description
Only when pressing the door request switch it is
possible to lock and unlock the door by carrying the Intelligent
Key.
INPUT SIGNAL AND OUTPUT SIGNAL
...
On Board Diagnostic (obd) System
Diagnosis Description
Diagnosis Description
This system is an on board diagnostic system that records exhaust
emission-related diagnostic information and detects a sensors/actuator-related
malfunction. A malfunction is indicated by the malfunction indicator lamp (MIL)
and stored in ...
Power Supply and Ground Circuit. Diagnosis Procedure
Diagnosis Procedure
Diagnosis Procedure
CHECK FUSES
Check that the following fuses are not blown:
...


