Nissan Sentra Service Manual: B terminal circuit
Description
“B” terminal circuit supplies power to charge the battery and to operate the vehicles electrical system.
Diagnosis procedure
Regarding wiring diagram information. Refer to chg-9, "wiring diagram".
1.Check “b” terminal connection
- Turn ignition switch off.
- Check if “b” terminal is clean and tight.
Is the inspection result normal? Yes >> go to 2.
No >> repair terminal “b” connection. Confirm repair by performing complete charging system test using the exp-800 ni or gr8-1200 ni (if available). Refer to applicable instruction manual for proper testing procedures.
2.Check “b” terminal circuit
Check voltage between generator “b” terminal and ground.
Is the inspection result normal? Yes >> go to 3.
No >> check harness for open between generator and fusible link.
3.Check “b” terminal connection (voltage drop test)
- Start engine, then engine running at idle and warm.
- Check voltage between battery positive terminal and generator connector “b” terminal.
Is the inspection result normal? YES >> “B” terminal circuit is normal. Refer to CHG-14, "Work Flow (With EXP-800 NI or GR8-1200 NI)" or CHG-17, "Work Flow (Without EXP-800 NI or GR8-1200 NI)".
NO >> Check harness between battery and generator for continuity.
Power generation voltage variable control system operation inspection
Diagnosis Procedure
Regarding wiring diagram information. Refer to chg-9, "wiring diagram".
Caution:
When performing this inspection, always use a charged battery that has
completed the ...
L terminal circuit (open)
Description
The “L” terminal circuit controls the charge warning lamp. The charge warning
lamp turns ON when the ignition
switch is set to ON or START. When the generator is providing su ...
Other materials:
Except 6M/T
EXCEPT 6M/T : Exploded View
Circular clip
Dust shield
Slide joint housing
Snap ring
Spider assembly
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circular clip
Joint sub-assembly
Wheel side
Joint sub-assembly
Circular clip
Boot band
Boot
Shaft
Da ...
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver and front passenger for certain
types of collision. Information necessary to service the system ...
Wiring diagram
Brake control system
Wiring Diagram
...
