Nissan Sentra B18 (2020-2025) Service Manual / Body Exterior, Doors, Roof & Vehicle Security / Door & Lock :: Dtc/circuit Diagnosis / B2f06-15 Back Door/trunk Opener Switch

Nissan Sentra B18 (2020-2025) Service Manual: B2f06-15 Back Door/trunk Opener Switch

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen items (Trouble diagnosis content)	DTC detecting condition
B2F06-15	Back door/trunk opener switch (Back door/trunk opener switch)	Diagnosis condition	Ignition switch ON
		Signal (terminal)	Trunk lid opener switch signal (BCM connector terminal: 12)
		Threshold	When the BCM detects the open or shorted circuit of the trunk lid opener switch
		Diagnosis delay time	1 second or less

POSSIBLE CAUSE

Trunk lid opener switch
Harness or connectors (trunk lid opener switch circuit is open or shorted)
BCM

FAIL-SAFE

–

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “BCM”.
Is DTC detected?
YES>>
Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair. Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK TRUNK LID OPENER INPUT SIGNAL

Ignition switch OFF.
Disconnect trunk lid opener switch connector.

Check voltage between trunk lid opener switch harness connector and ground.

(+)	(–)	Voltage (Approx.)
M15	2	Ground	Battery voltage

(+)

(–)

Voltage

(Approx.)

Trunk lid opener switch

Connector

Terminal

M15

Ground

Battery voltage

Is the inspection result normal?

YES >>

GO TO 3.

NO >>

GO TO 2.

CHECK TRUNK LID OPENER SWITCH CIRCUIT

Disconnect BCM connector.

Check continuity between BCM harness connector and trunk lid opener switch harness connector.

BCM		Trunk lid opener switch		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M84	12	M15	2	Yes

Check continuity between BCM harness connector and ground.

BCM		—	Continuity
Connector	Terminal	—	Continuity
M84	12	Ground	No

Is the inspection result normal?

YES >>

Replace BCM. Refer to Removal and Installation.

NO >>

Repair or replace harness.

CHECK TRUNK LID OPENER SWITCH GROUND CIRCUIT

Check continuity between trunk lid opener switch harness connector and ground.

Trunk lid opener switch		—	Continuity
Connector	Terminal	—	Continuity
M15	3	Ground	Yes

Is the inspection result normal?

YES >>

GO TO 4.

NO >>

Repair or replace harness.

CHECK TRUNK LID OPENER SWITCH
1. Refer to Component Inspection.
Is the inspection result normal?
YES>>
Replace BCM. Refer to Removal and Installation.
NO>>
Replace trunk lid opener switch. Refer to Removal and Installation.

 B2f06-11 Back Door/trunk Opener Switch

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC detecting condition B2F06-11 Back door/trunk opener switch (Back...

 B2001-45 Intelligent Key Unit

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B2001–45 Intelligent Key unit (Intelligent...

Other materials:

Manifold Absolute Pressure Sensor
Component Inspection Component Inspection CHECK MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR-1 Turn ignition switch OFF. Start engine and warm it up to normal operating temperature. Turn ...

Intelligent Key Battery. Removal and Installation
Removal and Installation Removal and Installation Release the lock knob at the back of the Intelligent Key and remove the mechanical key. Insert remover tool (A) wrapped with a cloth into the slit of the corner and twist it to separate the upper par ...

B0012-55 Active Vent
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...