Nissan Sentra B18 (2020-2025) Service Manual / Ventilation, Heater & Air Conditioner / Heater & Air Conditioning Control System :: Manual Air Conditioner / Dtc/circuit Diagnosis / B20c7-15 A/c Clutch

Nissan Sentra B18 (2020-2025) Service Manual: B20c7-15 A/c Clutch

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)		DTC detection condition
B20C7–15	A/C clutch (A/C clutch)	[CIRC SHORT TO BATT OR OPEN]	Diagnosis condition	When A/C switch is ON
			Signal (Terminal)	Magnetic clutch ON signal
			Threshold	Magnetic clutch ON signal circuit has a shorted to power or open
			Diagnosis delay time	1 second or more

POSSIBLE CAUSE

Harness or connectors (magnetic clutch ON signal circuit is shorted to battery or open)
IPDM E/R

FAIL-SAFE

Inhibit A/C compressor (magnetic clutch) operation

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Start the engine.
  2. Turn A/C switch ON.
  3. Select “Self Diagnostic Result” mode of “IPDM E/R”.
Is DTC detected?
YES>>
Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK MAGNETIC CLUTCH ON SIGNAL CIRCUIT FOR OPEN

Ignition switch OFF.
Disconnect IPDM E/R connector and A/C compressor connector.

Check continuity between IPDM E/R harness connector and A/C compressor harness connector.

IPDM E/R		A/C compressor		Continuity
Connector	Terminal	Connector	Terminal	Continuity
F96	65	F4	1	Yes

Is the inspection result normal?

YES >>

GO TO 2.

NO >>

Repair harness or connector.

CHECK MAGNETIC CLUTCH ON SIGNAL CIRCUIT FOR SHORT

Check voltage between IPDM E/R harness connectors and the ground.

+	–	Voltage (Approx.)
F96	65	Ground	0 V

–

Voltage

(Approx.)

IPDM E/R

Connector

Terminal

F96

Ground

0 V

Is the inspection result normal?

YES >>

GO TO 3.

NO >>

Repair harness or connector.

CHECK MAGNETIC CLUTCH GROUND CIRCUIT FOR OPEN

Check continuity between A/C compressor harness connectors and the ground.

A/C compressor		—	Continuity
Connector	Terminal	—	Continuity
F4	2	Ground	Yes

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair harness or connector.

 B20c7-11 A/c Clutch

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B20C7–11 A/C clutch (A/C clutch) [CIRCUIT ...

 B20c8-14 Compressor (ecv)

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B20C8-14 Compressor (ECV) [Compressor (elect...

Other materials:

Basic Inspection
Diagnosis and Repair Workflow Work Flow Work Flow OVERALL SEQUENCE DETAILED FLOW GET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incident/ma ...

Body Sealing
Description Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffecte ...

Seat. Preparation
Preparation Special Service Tool Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name ...