Nissan Sentra B18 (2020-2025) Service Manual / Ventilation, Heater & Air Conditioner / Heater & Air Conditioning Control System :: Manual Air Conditioner / Dtc/circuit Diagnosis / B20c7-11 A/c Clutch

Nissan Sentra B18 (2020-2025) Service Manual: B20c7-11 A/c Clutch

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)		DTC detection condition
B20C7–11	A/C clutch (A/C clutch)	[CIRCUIT SHORT TO GROUND]	Diagnosis condition	When A/C switch is ON
			Signal (Terminal)	Magnetic clutch ON signal
			Threshold	Magnetic clutch ON signal circuit has a shorted to ground
			Diagnosis delay time	1 second or more

POSSIBLE CAUSE

Harness or connectors (magnetic clutch ON signal circuit is shorted to ground)
IPDM E/R

FAIL-SAFE

Inhibit A/C compressor (magnetic clutch) operation

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Start the engine.
  2. Turn A/C switch ON.
  3. Select “Self Diagnostic Result” mode of “IPDM E/R”.
Is DTC detected?
YES >>
Refer to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

CHECK MAGNETIC CLUTCH ON SIGNAL CIRCUIT FOR SHORT

Ignition switch OFF.
Disconnect IPDM E/R connector and A/C compressor connector.

Check continuity between IPDM E/R harness connector and the ground.

IPDM E/R		—	Continuity
Connector	Terminal	—	Continuity
F96	65	Ground	No

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair harness or connector.

 Dtc/circuit Diagnosis

 B20c7-15 A/c Clutch

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B20C7–15 A/C clutch (A/C clutch) [CIRC SHO...

Other materials:

Exhaust System. Removal and Installation. Exhaust System
Exhaust System Exploded View Exploded View 1. Mounting rubber 2. Heated oxygen sensor 2 3. ...

Evap Canister Purge Volume Control Solenoid Valve
Removal and Installation Removal and Installation REMOVAL Disconnect harness connector (A) from EVAP canister purge volume control solenoid valve (3). Remove EVAP hose B (1) and EVAP hose C (2) from EVAP canister purge volume control solenoid valve. Remove nut ...

C161c-86 Steering Angle Sensor System
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...