Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Display Audio with Bose with 8" Color Display / Dtc/circuit Diagnosis / B13cf Buttons

Nissan Sentra B18 (2020-2025) Service Manual: B13cf Buttons

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
B13CF-73	Buttons (AV control unit)	Diagnosis condition	When ignition switch is ON.
		Signal (terminal)	—
		Threshold	—
		Diagnosis delay time	—

POSSIBLE CAUSE

AV control unit

FAIL-SAFE

AV control unit buttons error

Dtc Confirmation Procedure

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Ignition switch OFF and wait at least 30 seconds.
  3. Ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “MULTI AV”.
  5. Check DTC.
Is DTC B13CF–73 detected?
YES>>
Refer to DTC Diagnosis Procedure.
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>
Confirmation after repair: Inspection End.

Diagnosis Procedure

Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE AGAIN
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC B13CF–73 detected again?
YES >>
Replace AV control unit. Refer to Removal and Installation.
NO >>
Inspection End.

 B1383 Incomp Steering Angle Sensor Adjust

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1383–01 Incomp steering angle senor adjus...

 B1f05 Can Sig Error/diag

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1F05–29 CAN SIG ERROR/DIAG (CAN signal er...

Other materials:

Calibration of Decel G Sensor
Description Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed: Note: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration. ×: Required —: No ...

Door Motor Circuit
Diagnosis Procedure Diagnosis Procedure Note: If all of door motor DTCs are detected, check this circuit. CHECK DOOR MOTOR POWER SUPPLY Ignition switch ON. Check voltage between in ...

B1030 Front Seat Belt Force Limiter
Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition ...