S Nissan Sentra Manuals Library
Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Quick access Sentra Docs
B18 Owner's 2020-2025 Sentra owner information B18 Service 2020-2025 Sentra Workshop manual B17 Owner's 2013-2019 Sentra owner documentation B17 Service 2013-2019 Sentra service information

Nissan Sentra B18 (2020-2025) Service Manual: B1383 Incomp Steering Angle Sensor Adjust

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

B1383–01

Incomp steering angle senor adjust

(Steering angle sensor calibration)

Diagnosis condition

When ignition switch is ON.

Signal (terminal)

—

Threshold

—

Diagnosis delay time

—

POSSIBLE CAUSE

  • Neutral position adjustment of the steering angle sensor is incomplete

  • Steering angle sensor

FAIL-SAFE

Predictive course line is not displayed

Dtc Confirmation Procedure

DTC Confirmation Procedure

  1. PERFORM DTC CONFIRMATION PROCEDURE

    1. CONSULT

      1. Ignition switch ON.

      2. Ignition switch OFF and wait at least 30 seconds.

      3. Ignition switch ON and wait at least 30 seconds or more.

      4. Select “Self Diagnostic Result” mode of “MULTI AV”.

      5. Check DTC.

    Is DTC B1383–01 detected?

    YES>>

    Refer to DTC Diagnosis Procedure.

    NO>>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO>>

    Confirmation after repair: Inspection End.

Diagnosis Procedure

Diagnosis Procedure

  1. ADJUST NEUTRAL POSITION OF STEERING ANGLE SENSOR

    1. Adjusts the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Work Procedure.

      Note:

      When B1383–01 is detected, adjust the predictive course line center position of the steering angle sensor.

    >>

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE AGAIN

    1. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.

    Is DTC B1383–01 detected again?

    YES>>

    Replace steering angle sensor. Refer to Removal and Installation.

    NO>>

    Inspection End.

    B1360 Combination Meter
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B1360–02 Combination meter (Combination me...
    B13cf Buttons
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B13CF-73 Buttons (AV control unit) Diagnosis...

    Other materials:

    Rear-facing child restraint installation using the seat belts
    WARNING The three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint in the Nissan Sentra. Failure to activate and use the ALR mode will prevent the child restraint from being properly secured. An improperly installed restraint may tip or loos ...

    U1600 Front Left Door Speaker Out
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

    Interior Lighting System. Dtc/circuit Diagnosis
    Interior Room Lamp Battery Saver Output Circuit Diagnosis Procedure Diagnosis Procedure CHECK SYMPTOM Check symptom (A or B). A ...