Dtc Description
DTC DETECTION LOGIC
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
||
|---|---|---|---|---|
|
B1F05–29 |
CAN SIG ERROR/DIAG (CAN signal error/diagnosis) |
— |
Diagnosis condition |
When ignition switch is ON. |
|
Signal (terminal) |
CAN communication signal |
|||
|
Threshold |
Data error |
|||
|
Diagnosis delay time |
30 seconds or more |
|||
POSSIBLE CAUSE
BCM
Combination meter
ABS actuator and electric unit (control unit)
FAIL-SAFE
—
Confirmation Procedure
CHECK DTC PRIORITY
If DTC B1F05–29 is displayed with DTC U1000–01 or U1010–49, first perform the confirmation procedure for DTC U1000–01 or U1010–49.
Is DTC U1000–01 or U1010–49 detected?
YES >>U1000–01. Proceed to DTC Description.
U1010–49. Proceed to DTC Description.
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Ignition switch OFF and wait at least 30 seconds.
Ignition switch ON and wait at least 30 seconds or more.
Select “Self Diagnostic Result” mode of “AUDIO AMP.”.
Check DTC.
Is DTC B1F05–29 detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End
Dtc Diagnosis Procedure
PERFORM ALL DTC READING
CONSULT
Select “All DTC Reading”.
Check diagnosis results.
Are any DTCs detected?
YES>>Perform diagnosis procedure corresponding to DTC indicated.
NO>>Inspection End
U0079 Control Module Communication Bus G OffB1321 Front Right Tweeter
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection condition
...
Exploded View
Exploded View
1.
Blower unit
2.
Blower motor
...
P0445 Evap Canister Purge Volume Control Solenoid Valve
Dtc Description
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis
content)
DTC detection
condition
...