Diagnosis Procedure
CHECK SYSTEM SETTING
Turn ignition switch ON.
Check that the each system settings is selectable on the combination meter.
Is the inspection result normal?
YES >>GO TO 2.
NO >>GO TO 3.
PERFORM THE SELF-DIAGNOSIS
CONSULT
Perform “All DTC Reading”.
Check if the DTC is detected in self-diagnosis results of “ICC/ADAS” and “METER/M&A”. Refer to the following.
ICC/ADAS: Refer to DTC Index.
METER/M&A: Refer to DTC Index (4.2 inch information display) or DTC Index (7 inch information display).
Is any DTC detected?
YES >>Repair or replace malfunctioning parts.
NO >>Inspection End
CHECK STEERING SWITCH
Operate the steering switch to check that the information display on the combination meter operate properly.
Is the inspection result normal?
YES >>Replace the ADAS control unit. Refer to Removal and Installation.
NO >>Repair or replace malfunctioning parts.
Driver Assistance System Symptoms
Chime Does Not SoundDiagnosis and Repair Work Flow
Work Flow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
INTERVIEW FOR MALFUNCTION
It is also important to clarify the customer
concerns before starting the inspection. Interview the
customer about the concerns carefully and understand the
symptoms ...
P0524 Engine oil pressure
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0524
ENGINE OIL PRESSURE
(Engine oil pressure too low)
An EOP sensor signal voltage applied to
ECM remains lower than the specified ...
Blind Spot Warning (BSW)
WARNING
Failure to follow the warnings and instructions for proper use of the Blind
Spot Warning (BSW) system in the Nissan Sentra could result in serious injury or
death.
The BSW system is a driver assistance feature only and is not a substitute
for proper driving procedures. It is not ...