Nissan Sentra B18 (2020-2025) Service Manual: Accelerator Pedal Position Sensor
Component Inspection
Component Inspection
-
CHECK ACCELERATOR PEDAL POSITION SENSOR
-
Turn ignition switch OFF.
-
Reconnect all harness connectors disconnected.
-
Turn ignition switch ON.
-
Check the voltage between ECM harness connector terminals as per the following condition.
ECM
Condition
Voltage
Connector
+
–
Terminal
E16
160
161
Accelerator pedal
Fully released
0.3 - 0.6 V
Fully depressed
1.95 - 2.4 V
153
154
Fully released
0.6 - 0.9 V
Fully depressed
3.9 - 4.7 V
Is the inspection result normal?
YES >>INSPECTION END
NO >>Replace accelerator pedal assembly. Refer to Removal and Installation.
-
Other materials:
Evap Canister Purge Volume Control Solenoid Valve
Removal and Installation
Removal and Installation
REMOVAL
Disconnect
harness connector (A) from EVAP canister purge volume control
solenoid valve (3).
Remove EVAP
hose B (1) and EVAP hose C (2) from EVAP canister purge volume
control solenoid valve.
Remove nut
...
How to use the remote keyless entry function
The remote keyless entry function on the Nissan Sentra allows you to control
all door locks using the Intelligent Key. This convenient system enables locking
and unlocking of the doors from a distance of up to approximately 33 ft (10 m) away
from the vehicle, depending on surrounding condition ...
Preparation. Preparation
Preparation
Commercial Service Tools
Commercial Service Tools
Tool name
Description
Oil filter wrench
assortment
...