Nissan Sentra B18 (2020-2025) Service Manual: A/f Sensor 1 Heater
Component Inspection
Component Inspection
-
CHECK AIR FUEL RATIO (A/F) SENSOR 1 HEATER
-
Turn ignition switch OFF.
-
Disconnect air fuel ratio (A/F) sensor 1 harness connector.
-
Check resistance between A/F sensor 1 terminals as per the following.
A/F sensor 1
Condition
Resistance
+
−
Terminal
3
4
Temperature
25°C (77°F)
1.80 – 2.44 Ω
1
Not existed
2
4
1
2
Is the inspection result normal?
YES >>INSPECTION END
NO >>GO TO 2.
-
-
REPLACE A/F SENSOR 1
Replace A/F sensor 1. Refer to Exploded View.
CAUTION:
-
Discard any A/F sensor which has been dropped from a height of more than 0.5 m (19.7 in) onto a hard surface such as a concrete floor; use a new one.
-
Before installing new A/F sensor, clean exhaust system threads.
INSPECTION END
-
Other materials:
Body Sealing
Description
Description
The following figure shows the areas which are
sealed at the factory. Sealant which has been applied to these
areas should be smooth and free from cuts or gaps. Care should be
taken not to apply an excess amount of sealant and not to allow
other unaffecte ...
Mirrors. Symptom Diagnosis
Auto Anti-Dazzling Inside Mirror Does Not Operate. Diagnosis Procedure
Diagnosis Procedure
Diagnosis Procedure
CHECK AUTO-ANTI DAZZLING INSIDE
MIRROR SYSTEM
Check auto anti-dazzling inside mirror
system.
Is the inspe ...
Combination Switch Output Circuit. Diagnosis Procedure
Diagnosis Procedure
Diagnosis Procedure
CHECK OUTPUT 1 - 6 CIRCUIT FOR OPEN
Ignition switch OFF.
Disconnect BCM connector and combination switch
connectors.
...