Nissan Sentra manuals

Nissan Sentra Service Manual: Door parting seal

Exploded View


  1. Rear door panel
  2. Rear door parting seal
  3. Front door parting seal
  4. Front door panel

Front Pawl


Removal and InstallationFront


Removal and Installation

  1. Release parting seal pawls, then remove parting seal.

INSTALLATION

Installation is in the reverse order of removal.

Door outside molding
Exploded view Front door assembly Grommet Front door outside molding Rear door outside molding Rear door assembly Door glass  Clip Front door outside molding FRONT DOOR OUT ...

License lamp finisher
Exploded view Rear view camera Trunk lid opener request switch License lamp finisher Clip Pawl Removal and installation Remove trunk lid finisher. Refer to INT-45, "Removal ...

Other materials:

Passenger compartment
CAUTION Never use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not operate, check for an open fuse. NOTE: The fuse box is located on the driver’s side of the ...

Eps warning lamp does not turn on
Description EPS warning lamp does not turn ON when turning ignition switch ON from OFF. (Check the illumination of the EPS warning lamp.) Diagnosis Procedure 1.CHECK EPS WARNING LAMP Perform the trouble diagnosis of EPS warning lamp. Refer to STC-31, "Diagnosis Procedure". Is ...

Parts Requiring Angle Tightening
Use the Tool for the final tightening of the following engine parts: Tool number : KV10112100 (BT-8653-A) Camshaft sprocket (INT) bolt Cylinder head bolts Main bearing cap bolts Connecting rod cap bolts Crankshaft pulley bolt (No the angle wrench is required as bolt flange is pr ...

© 2014-2025 Copyright www.nisentra.com