Nissan Sentra Service Manual: A-bag branch line circuit

Nissan Sentra Service Manual / Electrical & power control / Lan system / Can system (type 2) / A-bag branch line circuit

Diagnosis procedure

Warning:

Always observe the following items for preventing accidental activation.

Before servicing, turn ignition switch off, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.)
Never use unspecified tester or other measuring device.

1.Check connector

Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the air bag diagnosis sensor unit for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace the main harness.

2.CHECK AIR BAG DIAGNOSIS SENSOR UNIT

Check the air bag diagnosis sensor unit. Refer to SRC-38, "Work Flow".

Is the inspection result normal? YES >> Replace the main harness.

NO >> Replace parts whose air bag system has a malfunction.

Tcm branch line circuit

Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and ...

Dlc branch line circuit

Diagnosis Procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal Check the terminals and connectors of the data link connector for ...

Other materials:

Description
NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing. Before performing trouble diagnoses, read the вЂњWork FlowвЂќ in each section. After repairs, re-check that the problem has been comp ...

Steering switch (meter control switch) signal circuit
Diagnosis Procedure Regarding wiring diagram information, refer to mwi-28, "wiring diagram". 1.Check combination meter input signal Turn ignition switch on. Measure voltage between the following terminals of the combination meter. Is the inspection result normal? Yes &g ...

Tcm branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side). TCM Harness connector F50 Harness co ...