Nissan Sentra Owners Manual: Child restraints
- Precautions on child restraints
- LATCH (Lower Anchors and Tethers for CHildren) System
- Rear-facing child restraint installation using LATCH
- Rear-facing child restraint installation using the seat belts
- Forward-facing child restraint installation using LATCH
- Forward-facing child restraint installation using the seat belts
- Installing top tether strap
- Booster seats
Larger children
Children should remain in a forward-facing child
restraint with a harness until they reach the maximum
height or weight limit allowed by the child
restraint manufacturer.
Once a child outgrows the ...
Precautions on child restraints
WARNING
Failure to follow the warnings and instructions
for proper use and installation
of child restraints could result in
serious injury or death of a child or
o ...
Other materials:
Condenser
Removal and installation
Removal
Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FINISHER
: Removal and Installation".
Disconnect the harness connectors (1), remove the condenser
bolt (A) and the condenser (2).
: Front
Installation
Installation is in th ...
On Board Diagnostic (OBD) System of Engine and CVT
The ECM has an on board diagnostic system. It will light up the malfunction
indicator lamp (MIL) to warn the
driver of a malfunction causing emission deterioration.
CAUTION:
Be sure to turn the ignition switch OFF and disconnect the
negative battery cable before any repair
or inspection ...
Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On
DIAGNOSTIC PROCEDURE
1.INSPECT BCM CONNECTOR
Turn ignition switch OFF.
Disconnect BCM connectors.
Check terminals for damage or loose connections.
Is the inspection result normal?
YES >> GO TO 2.
NO > ...
