Nissan Sentra Service Manual: Can system (type 4)
Dtc/circuit diagnosis
- Main line between ipdm-e and dlc circuit
- Main line between dlc and hvac circuit
- Ecm branch line circuit
- Abs branch line circuit
- Ipdm-e branch line circuit
- Tcm branch line circuit
- A-bag branch line circuit
- Dlc branch line circuit
- EPS branch line circuit
- M&A branch line circuit
- Strg branch line circuit
- Hvac branch line circuit
- BCM branch line circuit
- Can communication circuit
Can communication circuit
Diagnosis procedure
1.Connector inspection
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Disconnect all the unit connectors on CAN communication syste ...
Main line between ipdm-e and dlc circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and ...
Other materials:
Exterior lighting system symptoms
Symptom Table
Caution:
Perform the self-diagnosis with consult before the symptom diagnosis.
Perform the trouble diagnosis
if any dtc is detected.
Normal operating condition
Description
Auto light system
The auto light system may not turn the headlamp ON/OFF immediately after
pass ...
P0197, P0198 EOTSensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0197
EOT SEN/CIRC
(Engine oil temperature
sensor circuit low)
An excessively low voltage from the engine
oil temperature sensor ...
Steering column covers
Removal and Installation
REMOVAL
Remove the steering column cover screws (A), then remove the
steering column upper (1) and lower (2) covers.
NOTE:
Shown with steering wheel removed for clarity.
If necessary, rotate steering wheel to access steering column
cover screws (A).
...
