Nissan Sentra B18 (2020-2025) Service Manual: Work Procedure

Work Procedure

DESCRPITION

When replacing the EPS control unit, the procedures of BEFORE REPLACEMENT and AFTER REPLACEMENT must be performed. For work procedure, refer to the following:

• Before EPS control unit replacement.

• After EPS control unit replacement.

BEFORE REPLACEMENT

When replacing the EPS control unit, save “Operation log”.

AFTER REPLACEMENT

After replacing the EPS control unit, the following items must be performed:

• EPS control unit programming

• Adjust the neutral position of chassis control module (with built in steering angle sensor).

WORK PROCEDURE (BEFORE REPLACING EPS CONTROL UNIT)

1. SAVE “OPERATION LOG”

   1. CONSULT

      Save “Operation Log”, according to the procedure of “Programming” in CONSULT Operation Manual.

      Note:

      EPS control unit part number is saved in “Operation Log” saved in CONSULT.

   >>

   • Replace the EPS control unit. Refer to Removal and Installation.

   • After replacing the EPS control unit, perform necessary work.

WORK PROCEDURE (AFTER REPLACING EPS CONTROL UNIT)

1. CHECK “OPERATION LOG”

   1. CONSULT

      Check “Operation Log” saved before replacing the EPS control unit, according to the procedure of “Programming” in CONSULT Operation Manual.

      Note:

      For the Nissan Sentra vehicle that the programming is to be performed, check if “Operation Log” of Vehicle Identification Number (VIN) is in Saved Data List.

   Is there an applicable Operation Log in the Saved Data List?

   YES >>

   GO TO 2.

   NO >>

   GO TO 3.

2. PERFORM EPS CONTROL UNIT PROGRAMMING

   1. CONSULT

      Perform EPS control unit programming, according to “Programming” of CONSULT Operation Manual. Refer to CONSULT Operation Manual.

      CAUTION:

      During programming, maintain the following conditions:

      • Ignition switch: ON

      • Electric load: OFF

      • Steering wheel: Not steering

      • Battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)

      • Nissan Sentra Vehicle speed: 0 MPH

   >>

   GO TO 5.

3. READ IN EPS CONTROL UNIT PART NUMBER BY “FAST LINKED”

   1. Obtain EPS control unit part number by NISSAN PARTS CATALOGUE GLOBAL Web-FAST, according to the procedure of ‘FAST linked’ in CONSULT Operation Manual. Refer to CONSULT Operation Manual.

      CAUTION:

      Be sure to select “FAST linked”.

      Note:

      “FAST linked” allows an appropriate programming by obtaining ECU part number from NISSAN PARTS CATALOGUE GLOBAL Web-FAST even when the part number cannot be obtained from the old ECU used before replacing with a new one.

   >>

   GO TO 4.

4. PERFORM PROGRAMMING (FAST LINKED)

   1. CONSULT

      Perform EPS control unit programming according to the procedure of FAST linked in CONSULT Operation Manual. Refer to CONSULT Operation Manual.

      CAUTION:

      During programming, maintain the following conditions:

      • Ignition switch: ON

      • Electric load: OFF

      • Steering wheel: Not steering

      • Battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)

      • Nissan Sentra Vehicle speed: 0 MPH

   >>

   GO TO 5.

5. PERFORM NECESSARY WORK

   1. 1. Perform adjustment of chassis control module (with built in steering angle sensor) neutral position. Refer to Work Procedure.

      2. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

      3. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".

   >>

   End of work.