Nissan Sentra manuals

Nissan Sentra Service Manual: Wiring diagram

System
STARTING SYSTEM (WITH INTELLIGENT KEY) Component Parts Location Starter motor Transmission range switch (CVT Models) IPDM E/R (view with air inlet duct removed) Clutch interlock switc ...

Starting system (with intelligent key)
Wiring Diagram ...

Other materials:

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to lan-7, "can communication system : system description". Dtc logic Dtc detection logic Note: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symp ...

P0524 Engine oil pressure
DTC Logic DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition Possible cause P0524 ENGINE OIL PRESSURE (Engine oil pressure too low) An EOP sensor signal voltage applied to ECM remains lower than the specified ...

P0740 Torque converter
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0740 TORQUE CONVERTER (Torque Converter Clutch Circuit/ Open) The TCM torque converter clutch solenoid valve current monitor readi ...

В© 2014-2026 Copyright www.nisentra.com