Nissan Sentra manuals

Nissan Sentra Service Manual: Wiring diagram

BCM

Wiring diagram




Basic inspection


Ecu diagnosis information
Bcm Reference value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and d ...

Basic inspection
Inspection and adjustment Additional service when replacing control unit (bcm) Additional service when replacing control unit (bcm) : description Before replacement When replacing BCM, save or pr ...

Other materials:

Keyfob (if so equipped)
Replace the battery in the keyfob as follows: Remove the screw A . Insert a small screwdriver into the slit of the corner B and twist it to separate the upper part from the lower part. Use a cloth to protect the casing. Replace the battery with a new one. Do not touch the int ...

Rear drum brake
Exploded View Cap Bleeder valve Piston Spring Boot Piston cup Wheel cylinder Apply rubber grease Apply PBC (Poly Butyl Cuprysil) grease or silicone-based grease Apply brake fluid Disassembly and Assembly DISASSEMBLY Remove the boot from wheel cylinder. Refer t ...

P0506 ISC System
Description The ECM controls the engine idle speed to a specified level through the fine adjustment of the air, which is let into the intake manifold, by operating the electric throttle control actuator. The operating of the throttle valve is varied to allow for optimum control of the engine ...

В© 2014-2025 Copyright www.nisentra.com