Diagnosis Procedure
CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Check main power window and door lock/unlock switch.
Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace the malfunctioning parts.
REPLACE MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Replace main power window and door lock/unlock switch. Refer to Removal and Installation.
Confirm the operation after replacement.
Is the result normal?
YES >>Inspection End.
NO >>Check intermittent incident. Refer to Intermittent Incident.
When Power Window and Door Lock/unlock Switch Rh Is OperatedExhaust manifold
Exploded View
CALIFORNIA
Air fuel ratio sensor
Exhaust manifold heat shield (upper)
Exhaust manifold and three way catalyst
Exhaust manifold heat shield (rear)
Exhaust manifold heat shield (front)
Exhaust manifold gasket
Cylinder head
EXCEPT CALIFORNIA
Air fuel ratio ...
Dtc/circuit diagnosis
U1000 can comm
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
Dtc detection logic
Note:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual can diagnostic symptoms and ...
In-Cabin Microfilter
Removal and Installation
Removal and Installation
REMOVAL
Remove
glove box assembly. Refer to Removal and Installation.
Remove the
in-cabin microfilter cover.
Remove
in-cabin microfilter.
INSTALLATION
Installation is in the reverse order of
removal.
CAUTION: ...