Nissan Sentra Owners Manual: Warning/indicator lights and audible reminders
Anti-lock Braking System (ABS)
warning light
Brake warning light
Charge warning light
Door open warning light
Engine oil pressure warning
light
Low fuel warning light
Low tire pressure warning light
Low windshield-washer fluid
warning light
NISSAN Intelligent Key® lock
warning light
(M/T models) (if so equipped)
NISSAN Intelligent Key® warning
light (if so
equipped)
Power steering warning light
P position selecting warning
light
(CVT models) (if so equipped)
Seat belt warning light
Supplemental air bag warning
light
Continuously Variable
Transmission (CVT)
position indicator light (CVT models)
Cruise main switch indicator
light
(if so equipped)
ECO mode indicator light
Engine start operation indicator
light
(if so equipped)
Front fog light indicator light
(if so equipped)
Front passenger air bag status
light
High beam indicator light (blue)
Malfunction Indicator Light
(MIL)
Overdrive off indicator light (CVT
models)
Security indicator light
Side light and headlight
indicator light (green)
Slip indicator light
SPORT mode indicator light
Turn signal/hazard indicator
lights
Vehicle Dynamic Control (VDC)
off indicator
light
Compass display (if so equipped)
This unit measures terrestrial magnetism and indicates
heading direction of vehicle.
With the ignition switch in the ON position, press
the button as described in the
chart below
to activate ...
Checking bulbs
With all doors closed, apply the parking brake
and place the ignition switch in the ON position
without starting the engine. The following lights
will come on:
If equipped, the following lights ...
Other materials:
Wiring diagram
Power window system
Wiring Diagram
...
Door handle
Front door handle
Front door handle : exploded view
Outside handle bracket
Rear gasket
Front gasket
Outside handle escutcheon
Outside handle
Door key cylinder rod
Inside handle assembly
Front door handle : removal and installation
- inside handle
REMOVAL
Remove fr ...
Power supply and ground circuit
Combination meter
COMBINATION METER : Diagnosis Procedure
Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram".
1.Check fuses
Check that the following fuses are not blown.
Is the fuse blown?
Yes >> replace the blown fuse after repairing the affected circu ...
