Nissan Sentra manuals

Nissan Sentra Service Manual: Unit disassembly and assembly

Front drive shaft

Front drive shaft
6M/T 6M/T : Exploded View (LH) Front drive shaft Nut retainer Cotter pin Molykote M77 Front 6M/T : Removal and Installation (LH) NOTE: When removing components such as hoses ...

6M/T
6M/T : Exploded View (LH) Circular clip Dust shield Slide joint housing Snap ring Spider assembly Boot band Boot Shaft Damper band Dynamic damper Circular clip Joint sub ...

Other materials:

General Precautions
Always use a 12 volt battery as power source. Do not attempt to disconnect battery cables while engine is running. Before connecting or disconnecting the ECM harness connector, turn ignition switch OFF and disconnect negative battery cable. Failure to do so may damage the ECM because ...

Intake manifold tuning system
INTAKE MANIFOLD TUNING SYSTEM : System Description SYSTEM DIAGRAM SYSTEM DESCRIPTION This system switches the length of intake air path according to the low-to-medium speed range or high speed range. Torque is increased in the low-to-medium speed range and the engine output is improved ...

Engine oil
Inspection Engine oil level Note: Before starting engine, put vehicle horizontally and check the engine oil level. If engine is already started, stop it and allow 10 minutes before checking. Pull out oil level gauge and wipe it clean. Insert oil level gauge and check that the engine oil ...

В© 2014-2026 Copyright www.nisentra.com