Nissan Sentra manuals

Nissan Sentra Service Manual: Power generation voltage variable control system

Nissan Sentra Service Manual / Electrical & power control / Charging system / System description / Power generation voltage variable control system

System Diagram

System Description


System Description

Power generation variable voltage control system has been adopted. By varying the voltage to the generator, engine load due to power generation of the generator is reduced and fuel consumption is decreased.

NOTE:

When any malfunction is detected in the power generation variable voltage control system, power generation is performed according to the characteristic of the IC regulator in the generator.

Charging system
System Diagram System Description The generator provides DC voltage to operate the vehicle's electrical system and to keep the battery charged. The voltage output is controlled by the IC ...

Wiring diagram
Charging system Wiring Diagram ...

Other materials:

NISSAN Vehicle Immobilizer System keys
You can only drive your vehicle using the master keys which are registered to the NISSAN Vehicle Immobilizer System components in your vehicle. These keys have a transponder chip in the key head. The master key can be used for all the locks. Never leave these keys in the vehicle. Addition ...

Removal and installation
SIDE OIL SEAL Removal and Installation REMOVAL Remove front drive shafts. Refer to FAX-18, "6M/T : Removal and Installation (LH)". Remove differential side oil seals (1) from clutch housing and transaxle case using a suitable tool. CAUTION: Do not damage transaxle case an ...

Rear power window switch
Removal and Installation REMOVAL Release the pawls using a suitable tool and lift the rear power window switch and finisher as an assembly and remove Disconnect the harness connector from the rear power window switch. Release the pawl (one on each side) using a suitable tool, then se ...

В© 2014-2026 Copyright www.nisentra.com