Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual: U215b Can Comm Err (ipdm E/r)

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

U215B–87

CAN comm err (IPDM E/R)

[CAN communication error (IPDM E/R)]

Diagnosis condition

Ignition switch ON

Signal (terminal)

CAN communication signal

Threshold

Communication error

Diagnosis delay time

2 seconds or more

POSSIBLE CAUSE

CAN communication system (IPDM E/R)

FAIL-SAFE

Obstacle detection is disabled

Confirmation Procedure

Confirmation Procedure

  1. DTC CONFIRMATION PROCEDURE

    1. CONSULT

      1. Ignition switch ON.

      2. Ignition switch OFF and wait at least 30 seconds.

      3. Ignition switch ON and wait at least 2 seconds or more.

      4. Select “Self Diagnostic Result” mode of “SONAR”.

    Is DTC U215B–87 detected?

    YES>>

    Refer to DTC Diagnosis Procedure.

    NO>>

    To check malfunction symptom before repair: Refer to Intermittent Incident.

    NO>>

    Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

  1. PERFORM DTC CONFIRMATION PROCEDURE AGAIN

    1. CONSULT

      1. Ignition switch ON.

      2. Erase DTC.

      3. Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.

    Is DTC U215B–87 detected?

    YES>>

    Perform the trouble diagnosis for CAN communication system. Refer to Trouble Diagnosis Flow Chart.

    NO>>

    Inspection End.

    U2152 Can Comm Err (adas Control Unit)
    Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2152–87 CAN comm err (ADAS control unit) ...
    Power Supply and Ground Circuit. Diagnosis Procedure
    Diagnosis Procedure Diagnosis Procedure CHECK FUSE Check that the following fuse is not blown: Terminal No. Signal name Fuse No. Capacity 12 Ignition power supply 49 10 A Is the...

    Other materials:

    Fuel Pump
    Component Inspection Component Inspection CHECK FUEL PUMP Turn ignition switch OFF. Disconnect “fuel level sensor unit and fuel pump” harness connector. Check the resistance between ...

    Seat belt warning light and chime
    The driver and front passenger seats in the Nissan Sentra are equipped with an enhanced seat belt reminder system. When this feature is active, both a visual warning and an audible chime will operate if the driver or front passenger seat belt remains unbuckled while the vehicle is travelin ...

    Manifold Absolute Pressure Sensor
    Component Inspection Component Inspection CHECK MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR-1 Turn ignition switch OFF. Start engine and warm it up to normal operating temperature. Turn ...