Nissan Sentra B18 (2020-2025) Service Manual: U1010 Control Unit(can)

Nissan Sentra B18 (2020-2025) Service Manual / Driver Information & Multimedia / Audio, Visual & Navigation System :: Intelligent Around View Monitor System / Dtc/circuit Diagnosis / U1010 Control Unit(can)

Dtc Description

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
U1010–00	CONTROL UNIT(CAN) [Control unit (CAN)]	Diagnosis condition	When ignition switch is ON
		Signal (terminal)	—
		Threshold	—
		Diagnosis delay time	—

POSSIBLE CAUSE

Around view monitor control unit

FAIL-SAFE

Intelligent around view monitor system is inoperative.

Confirmation Procedure

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Select “Self Diagnostic Result” mode of “AVM”.
  3. Check DTC.
Is DTC U1010–00 detected?
YES >>
Proceed to DTC Diagnosis Procedure.
NO >>
To check malfunction symptom before repair: Refer to Intermittent Incident.
NO >>
Confirmation after repair: Inspection End.

Dtc Diagnosis Procedure

DTC Diagnosis Procedure

PERFORM DTC CONFIRMATION PROCEDURE
1. CONSULT
  1. Ignition switch ON.
  2. Erase DTC.
  3. Select “Self Diagnostic Result” mode of “AVM”.
  4. Check DTC.
Is DTC U1010–00 detected?
YES>>
Replace around view monitor control unit. Refer to Removal and Installation.
NO>>
Inspection End.

C1a39 Strg Sen Cir

Dtc Description DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms ...

Other materials:

Exploded View
Exploded View STANDARD ROOF 1. Front room/map lamp assembly bracket 2. Headlining 3. ...

USB (Universal Serial Bus) Connection Port
Type-A. Connecting a device to the USB Connection Port WARNING Do not connect, disconnect, or operate the USB device while driving. Doing so may distract the driver. If distracted, you could lose control of your Nissan Sentra, which may result in an accident causing serious injury or ...

Low tire pressure warning lamp does not turn oFF
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On DIAGNOSTIC PROCEDURE 1.INSPECT BCM CONNECTOR Turn ignition switch OFF. Disconnect BCM connectors. Check terminals for damage or loose connections. Is the inspection result normal? YES >> GO TO 2. NO > ...