Nissan Sentra Service Manual: U1000 CAN Comm circuit
DTC Logic
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction detected condition | Possible causes |
| U1000 | CAN COMM CIRCUIT | When CAN communication signal is not continuously received for 2 seconds or more | CAN communication system malfunction |
Diagnosis Procedure
1.CHECK DTC DETECTION
With CONSULT
-
Turn ignition switch ON.
-
Perform self diagnostic result.
Is DTC U1000 detected? YES >> Proceed to diagnosis procedure. Refer to LAN-16, "Trouble Diagnosis Flow Chart".
NO >> Refer to GI-39, "Intermittent Incident".
C1164, C1165, C1166, C1167 CV/SV System
DTC Logic
Dtc detection logic
DTC
Display Item
Malfunction detected condition
Possible causes
C1164
CV 1
When a malfunction is detected in cut valve 1.
Har ...
U1002 System comm (CAN)
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
U1002
SYSTEM COMM(CAN)
When ABS actuator and electric unit (control unit) ...
Other materials:
System
Warning chime system
Warning chime system : system diagram
Warning chime system : system description
Description
The buzzer for warning chime system is installed in the combination
meter.
The buzzer sounds when the combination meter receives a buzzer output
signal from the bcm.
Th ...
Drive belt
Exploded View
Alternator
Drive belt auto-tensioner
Crankshaft pulley
A/C compressor
Water pump
Drive belt
Possible use range
New drive belt range
Indicator
Removal and Installation
REMOVAL
Remove the front fender protector (RH) front side bolts and clips. Refer ...
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
try the following solutions.
Where the solutions are listed by number, try
each solution in turn, starting with number 1, until
the problem is resolved.
Symptom
Solution
...
