Nissan Sentra Service Manual: Wiring diagram

Ecu diagnosis information

BCM Reference value Note: The signal tech ii tool (j-50190) can be used to perform the following functions. Refer to the signal tech ii user guide for additional information. Activate and di ...

Basic inspection

Inspection and adjustment Additional service when replacing control unit (bcm) ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description Before replacement When replacing bcm, save or pri ...

Other materials:

NISSAN Vehicle Immobilizer System keys
You can only drive your vehicle using the master keys which are registered to the NISSAN Vehicle Immobilizer System components in your vehicle. These keys have a transponder chip in the key head. The master key can be used for all the locks. Never leave these keys in the vehicle. Addition ...

DTC/Circuit diagnosis
POSITION SWITCH BACK-UP LAMP SWITCH BACK-UP LAMP SWITCH : Component Inspection 1.CHECK BACK-UP LAMP SWITCH Disconnect position switch harness connector. Refer to TM-21, "Removal and Installation". Check continuity between position switch terminals. Is the inspection ...

How to erase permanent  DTC
Description OUTLINE When a DTC is stored in ECM When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL shutoff if the same malfunction is not detected after performing the driving pattern for MIL shutoff three times in a raw. *1: When the same malfunction is detec ...