Component Inspection

Component Inspection

1. CHECK THROTTLE POSITION SENSOR

   1. Turn ignition switch OFF.

   2. Reconnect all harness connectors disconnected.

   3. Perform “Throttle Valve Closed Position Learning”. Refer to Work Procedure.

   4. Turn ignition switch ON.

   5. Set selector lever to D position.

   6. Check the voltage between ECM harness connector terminals as per the following conditions.

      ECM			Condition		Voltage
      Connector	+	–
      	Terminal
      F25	85	90	Accelerator pedal	Fully released	More than 0.36 V
      				Fully depressed	Less than 4.75 V
      	89			Fully released	Less than 4.75 V
      				Fully depressed	More than 0.36 V

   Is the inspection result normal?

   YES >>

   INSPECTION END

   NO >>

   Replace electric throttle control actuator. Refer to Removal and Installation.