Factory-style information for owners and repair work

Nissan Sentra techinfo

Find Nissan Sentra owner information, maintenance instructions, technical references, service procedures and useful repair pages in one clean online library.

Nissan Sentra B18 (2020-2025) Service Manual: Throttle Control Motor

Component Inspection

Component Inspection

  1. CHECK THROTTLE CONTROL MOTOR

    1. Turn ignition switch OFF.

    2. Disconnect electric throttle control actuator harness connector.

    3. Check the resistance between electric throttle control actuator terminals as per the following.

      Electric throttle control actuator

      Condition

      Resistance

      Terminal

      5

      6

      Temperature

      25°C (77°F)

      1 – 15 Ω

    Is the inspection result normal?

    YES >>

    INSPECTION END

    NO >>

    Replace electric throttle control actuator. Refer to Removal and Installation.

    Sensor Power Supply 2 Circuit
    Diagnosis Procedure Diagnosis Procedure ECM supplies a voltage of 5 V to some of the sensors systematically divided into 2 groups, respectively.Accordingly, when a short circuit...
    Throttle Position Sensor
    Component Inspection Component Inspection CHECK THROTTLE POSITION SENSOR Turn ignition switch OFF. Reconnect all harness connectors disconnected. Perform “Throttle Valve Close...

    Other materials:

    P061b Ecm
    Dtc Description DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition ...

    Periodic Maintenance. Headlamp
    Headlamp Aiming Adjustment Aiming Adjustment PREPARATION BEFORE ADJUSTING Before performing aiming adjustment, check the following: Ensure all tires are inflated to correct pressure. Place Nissan Sentra vehicle and screen on level surface. ...

    Tire pressure
    Tire Pressure Monitoring System (TPMS) WARNING Radio waves emitted by the Tire Pressure Monitoring System (TPMS) may adversely affect certain types of electronic medical equipment. Individuals who use a pacemaker or other implanted medical devices should contact the medical equipment manufact ...