Preparation
Component partsDoor mirror remote control switch
Removal and Installation
Removal
Remove the instrument finisher D. Refer to IP-14, "Exploded View".
Using suitable tool (a) release the pawls and remove the door mirror
remote control switch (2) from the
switch bracket (1).
Pawl
Installation
Installation is in the rev ...
Interior room lamp control circuit
Description
Controls each interior room lamp (ground side) by pwm signal.
Note:
Pwm signal control period is approximately 250 hz (in the gradual
brightening/dimming).
Component function check
Caution:
Before performing the diagnosis, check that the following are normal.
Interior room l ...
Does not stop fully-open or fullyclosed
position
Diagnosis procedure
1. Perform initialization procedure
Perform initialization procedure.
Refer to RF-18, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair
Requirement".
Is the inspection result normal?
YES >> Inspection End.
NO >> Perform basic ins ...