Nissan Sentra B18 (2020-2025) Service Manual: Symptom Diagnosis. Intelligent Around View Monitor System
Intelligent Around View Monitor System
Symptom Table
INTELLIGENT AROUND VIEW MONITOR SYSTEM
Note:
Inspect the Nissan Sentra vehicle for a front license plate frame or cover. If there is a front license plate frame or cover, the front camera will see it and show it on the monitor.
|
Symptom |
Check items |
Probable malfunction location |
|
|---|---|---|---|
|
Screen is not switched to camera image when CAMERA button is pressed or when shift position is shifted to “R”. |
“AVM” is not displayed on the system selection screen of CONSULT. |
Around view monitor control unit power supply or ground circuit. Refer to Diagnosis Procedure. |
|
|
Check that Data Monitor item values are normal using CONSULT:
|
CAMERA SWITCH SIGNAL and REVERSE SIGNAL are normal. |
Around view monitor control unit. Refer to Removal and Installation. |
|
|
CAMERA SWITCH SIGNAL is not normal. |
Camera switch signal circuit. Refer to Reference Value. |
||
|
REVERSE SIGNAL is not normal. |
Reverse signal circuit. Refer to Reference Value. |
||
|
Check the following Data Monitor item using CONSULT:
|
F-CAMERA IMAGE SIGNAL: NG |
Front camera power supply circuit and image signal circuit. Refer to DTC Diagnosis Procedure. |
|
Check the following Data Monitor item using CONSULT:
|
REAR CAMERA IMAGE SIGNAL: NG |
Rear camera power supply circuit and image signal circuit. Refer to DTC Diagnosis Procedure. |
|
LH side of around view screen is not displayed. |
Check the following Data Monitor item using CONSULT:
|
DR-SIDE CAMERA IMAGE SIGNAL: NG |
Side camera LH power supply circuit and image signal circuit. Refer to DTC Diagnosis Procedure. |
|
Check the following Data Monitor item using CONSULT:
|
PA-SIDE CAMERA IMAGE SIGNAL: NG |
Side camera RH power supply circuit and image signal circuit. Refer to DTC Diagnosis Procedure. |
Camera Image Signal Circuit
Diagnosis Procedure
Diagnosis Procedure
CHECK CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY
Ignition switch OFF.
...
Other materials:
Removal and installation
Combination meter
Exploded view
Combination meter
Front cover
Removal and installation
Removal
Remove cluster lid a. Refer to ip-19, "removal and installation".
Remove the screws from the combination meter.
Remove the combination meter.
Disconnect the comb ...
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 2,500 rpm under no load (for example, the
selector lever position is neutral and
engine speed is over 2,500 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
b ...
System description
Component parts
Component parts location
Front tweeter lh
GPS antenna
Steering switches
Av control unit
Front tweeter rh
Microphone
Front door speaker LH
Front door speaker rh
Rear speaker RH
Rear speaker lh
Antenna amp.
Satellite antenna
Rear view camera
Window a ...