Nissan Sentra manuals

Nissan Sentra Service Manual: Symptom diagnosis

Starting system

Symptom table

Symptom

Reference

No normal cranking Refer to STR-20, "Work Flow (With GR8-1200 NI)" or STR-24, "Work Flow (Without GR8-1200 NI)".
Starter motor does not rotate
S connector circuit
Description The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P (Park) or N (Neutral) position (C ...

Removal and installation
Starter motor Exploded View “S” terminal harness “B” terminal harness Starter motor Cylinder block Removal and Installation NOTE: When removing components such ...

Other materials:

Rear lh side power window does not operate
When both power window main switch and rear power window switch lh are operated When both power window main switch and rear power window switch lh are operated : diagnosis procedure 1.CHECK REAR POWER WINDOW SWITCH LH Check rear power window switch LH. Refer to PWC-40, "REAR POWER WIN ...

Additional service when replacing ecm
Description When replacing ECM, the following procedure must be performed. (For details, refer to EC-135, "Work Procedure".) PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sure to follow the procedure to perform t ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...

© 2014-2026 Copyright www.nisentra.com