Nissan Sentra Service Manual: Symptom diagnosis

S terminal circuit

Description The output voltage of the generator is controlled by the IC regulator at terminal “S” detecting the input voltage from battery. The “S” terminal circuit detects ...

Removal and installation

Generator Exploded view Thermostat housing Generator bolt (upper) Generator bolt (lower) Generator B” terminal harness “B” terminal nut Generator harness connector ...

Other materials:

Forward-facing child restraint installation using the seat belts
WARNINGThe three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a c ...

Repairing material
Foam Repair During factory assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators. URETHANE FOAM APPLICATIONS Use commercially available Urethane foam for sealant (foam m ...

Floor trim
Exploded View Floor trim Harness protector Front floor spacer (RH) Front floor spacer (LH) Rear floor spacer (LH) Rear floor spacer (RH) Column hole cover Pawl Front Removal and Installation REMOVAL Remove front seat assemblies. Refer to the following. Refer to S ...