Nissan Sentra Service Manual: Symptom diagnosis
Push-button ignition switch does not operate
Description
Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.
Note:
The engine start function, door lock function, power distribution system, and nats-ivis/nvis in the intelligent key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.
Conditions of vehicle (operating conditions)
- “Engine start by i-key” in “work support” is on when setting on consult.
- One or more of Intelligent Keys with registered Intelligent Key ID is in the vehicle.
Diagnosis procedure
1.Perform work support
Perform “inside ant diagnosis” on work support of “intelligent key”.
Refer to pcs-66, "intelligent key : consult function (bcm - intelligent key)".
>> Go to 2.
2.Perform self-diagnosis result
Perform self-diagnosis result of “bcm”.
Is dtc detected? Yes >> refer to bcs-49, "dtc index".
No >> go to 3.
3.Check push-button ignition switch
Check push-button ignition switch.
Refer to pcs-98, "component function check".
Is the operation normal? Yes >> go to 4.
No >> repair or replace malfunctioning parts.
4.Confirm the operation
Confirm the operation again.
Is the inspection normal? Yes >> check intermittent incident. Refer to gi-39, "intermittent incident".
No >> go to 1.
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to lan-7, "can communication system : system description".
DTC Logic
Dtc detection logic
Note:
U1000 can be set if a module harness was discon ...
Removal and installation
Push-button ignition switch
Removal and installation
Removal
Remove the nats antenna amp. Refer to sec-135, "removal and
installation"
Remove the push-button ignition switch.
I ...
Other materials:
Strg branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor for
damage, bend and loose connection
(unit side and connector side).
Is the inspection result ...
Radio
With the ignition placed in the ACC or ON position,
press the PWR (power)/VOL (volume) knob
to turn the radio on. If you listen to the radio with
the engine not running, the ignition should be
placed in the ACC position.
Radio reception is affected by station signal
strength, distance from r ...
Eps branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the eps control unit for damage,
bend and loose connection (unit
side and connector side).
Is the inspection result norm ...
