Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Push-button ignition switch

Removal and installation

Removal

  1. Remove the nats antenna amp. Refer to sec-135, "removal and installation"
  2. Remove the push-button ignition switch.

Installation

Installation is in the reverse order of removal.

Symptom diagnosis
Push-button ignition switch does not operate Description Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom. N ...

Charging system
...

Other materials:

Precaution
Precaution for supplemental restraint system (srs) "air bag" and "seat belt pre-tensioner" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injur ...

B0097 Rear side air bag satellite sensor RH
Description DTC B0097 REAR SATELLITE SENSOR RH The rear side air bag satellite sensor RH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor the rear side air bag satellite sensor RH for internal failures and its circuits for communication errors. P ...

Uniform tire quality grading
DOT (Department of Transportation) Quality Grades: All passenger car tires must conform to federal safety requirements in addition to these grades. Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200 ...

© 2014-2026 Copyright www.nisentra.com